Powr-Flite Black Backpack V...
$65.99
Product details
X9812 is a black strap sized to fit backpack vacuum harnesses. Every pound of a loaded unit passes through this single component for a full shift, and the webbing is usually what gives out: it thins where it rides through the buckle, stitching pulls loose at the anchor point, and a hardware clip can eventually let go without any warning beforehand.
A given harness is built from several straps rather than one, and the shoulder, chest, and waist pieces on a single frame are rarely the same length or hardware as each other. Straps are also not standardized between manufacturers, so a piece that fits comfortably on one backpack will not necessarily suit another model even when the two units look similar side by side or share roughly the same general harness layout.
Before you place an order, lay the strap coming off the machine flat and measure it end to end, then check its webbing width and clip style against X9812, or have your machine's model on hand so the fit can be confirmed ahead of time. A strap that is close but not exact tends to bind at the buckle or leaves too much slack once the pack is loaded and worn.
Once it is installed, cycle the strap through its full adjustment range before putting the unit back into service. It should slide freely at every setting and lock without creeping under load, since one that only holds at a single length is not seated correctly and will loosen again mid-shift.
- Part: X9812
- Color: black
- Fits: backpack vacuum harness assemblies
- Sold: one strap per order