Power Star Optima Plus Cont...
$72.99
Product details
The Optima Plus is a central vacuum built by Power Star, and part ELECIR901 is its replacement control module, covering units made after 2010. Every wall inlet in the system sends its start signal to this one board, which reads that low-voltage signal and switches the higher-voltage circuit that spins up the motor.
A dying board rarely quits all at once. The earlier warning signs tend to be small: the unit needs the hose plugged and unplugged twice before it fires, it hesitates a beat longer than usual, or it runs fine for a stretch and then cuts out once the motor comes under real load. Those same symptoms can look like a tired motor from the outside, which is exactly why a working motor sometimes gets swapped out first while the actual fault sits on this board.
Manufacturer compatibility data extends this board well past the Optima Plus itself, covering the Titan TCS4792 and TCS7702, a long CycloVac lineup spanning the E215 through the H725 and the HD800 series, the Solution 600, 600T, and 700, and the Mvac M43, M45, M47, M50, M65, M80, and M95.
The after-2010 cutoff applies specifically to the Optima Plus, where this board is listed only for units built after that year rather than across the model's whole production run. Check your unit's exact model, and for the Optima Plus roughly when it went in, before placing an order.
- Part: ELECIR901, Power Star Optima Plus control module
- Fits: Power Star Optima Plus (2010 and later), Titan TCS4792/TCS7702, CycloVac E-series, GS-series, and H-series, HD800 series, Solution 600/600T/700, Mvac M43, M45, M47, M50, M65, M80, M95
- Symptoms it addresses: hesitates to start, needs the hose replugged to fire, cuts out under load