Hoover Brush Roll / - SH400...
$21.99
Product details
Part 440001575 is the brush roll for the Hoover SH40060 cyclonic canister vacuum, and it is listed as the correct roll for the SH40080 and the SR30018 as well.
The roll is the one part inside a canister nozzle that actually touches carpet pile, and it wears the way any bristled roller does: the tufts flatten and shorten with use, and a machine that used to leave visible cleaning lines starts leaving matted pile behind instead. Hair and thread wrapped around the shaft produce the same flat, ineffective pass, so clear the roller of debris before deciding the bristles themselves are worn.
Canister nozzles like this one are compact, and the roll spins inside a housing set close to the carpet, so it picks up wound hair faster than a full-size upright roll of similar diameter would. Working the roller free of hair every few uses, rather than only when the nozzle has already gone quiet, keeps the bearings from taking on the extra load of a bound-up roller.
Spin the new roll by hand before installing it, and once it is fitted, check that it turns freely without dragging on the nozzle housing. A roll that catches at one end points to a bearing or end-cap problem rather than the bristles, and no amount of adjustment corrects drag that mechanical wear has already caused.
- Part: 440001575, brush roll
- Fits: Hoover SH40060, SH40080, SR30018
- Before ordering: confirm against your machine's part diagram, since canister nozzle rolls vary in width and end-cap style across models