Trovac 120V Power Cord for ...
$22.00
Product details
Part ELECOR01 is a Trovac 120V power cord built to replace the lead that feeds a central vacuum power unit's motor circuit. Once the original cord frays, cracks, or works loose at the plug, symptoms usually follow close behind: the unit refuses to start, cuts out mid-clean, or only runs when the cord sits in one exact position against the wall.
Cord failures rarely happen all at once. Insulation near the strain relief flexes every time someone coils or moves the cord, so that section thins out first and eventually splits, long before the wire itself gives out. A power unit that starts fine one day and not the next, with no change to the motor or the switch, is telling you the fault sits in the cord rather than deeper in the unit. Catching a cracked jacket early also heads off a bigger repair, since exposed wire near a plug is a hazard as much as a nuisance, and a unit that will not start reliably at the wall is not a safe one to keep running while you decide whether to replace the lead.
- Part: ELECOR01
- Rating: 120V
- Use: mains supply lead for a central vacuum motor circuit
Swap this lead in once the original shows cracking, fraying, or an intermittent start. Before ordering, check the plug and connector style on your existing unit against this cord, since power units terminate the lead at the motor housing in more than one way, and a mismatched connector will not seat correctly even if the cord itself is otherwise a fit. Mains-level wiring is not a place to guess, so have someone qualified make the actual connection at the unit rather than working it out on the spot.